Round Flat Panel Led Lights , 180x15mm SMD3014 Chips Panel Lighting

LED Panel has been design to work with conventional Grid Panel Light with fluorescent tube
fixtures. To replace the short lived fluorescent lamps that are typically used in interior lighting.
The LED Panel can be used to retrofit existing fluorescent tube grid light installations in all types
of applications .
 

Features:

1. round panel led ,Energy Saving. Saving 55%-70% electricity cost to traditional Panels.
2. Advanced super longlife and stable driver.
3. Professional thermal management.
4. Instant on, no warm up time required.
5. No noise, no flickering.
6. No UV or IR radiation in the beam, mercury free.
7. Anti-shock, anti-moisture.
8. Aluminum alloy 6063 body and leading light transmitting Optical PMMA cover.
9. Exquisite small appearance. Easy to install with mounting brackets.
10. Eco-friendly. No mercury and other harmful materials
11. No delay on start.
12. Long life span, longer than 40,000H

Storage condition:

The LEDs better be kept at <30°C & < 60%RH.
Please avoid conditions which may cause the LEDs being corroded or discolored. The corrosion or discoloration might lower solderability or affect optical characteristics.
Please avoid rapid transition in ambient temperature, especially in high humidity environments where condensation can occur.
 

Products diagram:

Package show:

Installation Guide :

Products show:

Certificate:

Attention on Installation:

1. Panel lights should be installed by trained electronic technician.
 

2. Please check all the accessories when open the cartons.
 

3. The distance between the light and any flammable materials must be more than 0.2m. The distance between the upper part of the installed light and the ceiling must not be less than 2 cm. Don not install into ceilings or walls that contain heat source. The main cable must not connect with the low voltage cable or the surface-mounted lights.
 

4. Guide the lights' connecting cables through the drilled hole, and fix the surface-mounted lights with the pre-fitted clips. Make sure that these are securely connected to the base material.
 

5. When laying the cables, make sure that the cables and plugs are not subjected to any tensile or twisting forces. Do not kink cables. Output cables should be laid separately and at a distance from other cables.
 

6. After installation, connect the transformer to the mains supply
 

7. Proceed by connecting the wiring cables to the lights. Usually, the brown (or black) wire is the Live wire, connect it with the terminal marked "L". The blue wire is Naughty wire; connect it with the terminal marked "N".
 

8. Use the dedicated LED drivers only, do not connect to other loads
 

9. Do not remove the label of the lights and drivers.
 

Notes on Using:

1. Please always use the light out of its package.
 

2. Before starting use of the light, please check if the light was damaged during transportation. If any damage shown, please DO not install or use it.
 

3. Any maintenance should be performed by trained profes